dzino rašė:Gal kas pagelbes, noriu pasikeist zibinta saab 93 2003metu, kaip islupt zibinta kad pakeist ji nauju? google issukavau - neradau...
gal kas keitesi zibinta is jusu...
buvau isemes abu zibintus nieko ten sudetingo, nusiemi bamperi ir viskas kaip ant delno.
Front bumper shell removal:
Tools you'll need?
Small socket set (metric)
Thing shafted flathead
Like, 15 minutes.
Okay, so let's get started
Step 1 - Remove the upper radiator crossmember clips
Note: I found these easy to get around after you get used to them. Take a screwdriver and push down on the circle in the middle. This will push the pin out, and with luck - fall on the ground below the car. Then pull up on the shell to pull the mount out. There are six of these, make sure you don't lose anything!
Step 3 - Remove bumper bolts in wing liner
Step 4 - Remove the spoiler shield (If your car has headlight washers, you're going to need to unplug them and suspend/cap them)
Note: You don't need to unplug that connector, either - unless you plan on moving the bumper more then a few feet away
Step 5 - Pull the corner of the bumper shell loose from the holder mounting
Note: You can tug a little bit, but not too hard. For me, this didn't get me anywhere. However, if you get a plastic wedge or a thin shafted flathead screwdriver, you can pry downwards and the clips will disconnect. Kind of make a loud noise, but trust me they are fine. They are several, so just keep going until that end up the bumper is pretty much hanging. Go do the other side - only took a second with the screwdriver method
Step 6 - Lift off the shell!
To put back on - pretty much everything in reverse. One note for putting the bumper back on concerning the side clips. Push them into position - then bang with your fist. Hard. You'll get it on there. Make sure you guided the clips in so they will actually connect when you bang them into place, though.
va tik ka bandziau nupoliruot ta "mutnesni" bet vistiek nekas, smulkiu pazeidimu turi nemazai... 